Eddy DK Programmer Guide
2.6.1.1. S2 : GPIO Input Configuration
After configure PB0-PB4 to input, you can confirm whether the input value is changing with dip switch control.
2.6.1.2. S3,4 : Terminal Resistor selection
COM Port #3 and COM Port #4 is Combo port which support RS422/RS485 interface. Terminal resistors in each port
are configured by switch upon each Terminal Block.
RS422 Termination Resistor not connected
RS422 Termination Resistor Connected
RS485 Termination Resistor not connected
RS422 Termination Resistor Connected
RS422 Termination Resistor not connected
RS422 Termination Resistor Connected
RS485 Termination Resistor not connected
RS422 Termination Resistor Connected
2.6.1.3. J6,J7 : JIG Board connector(Socket)
Commentaires sur ces manuels